Thingiverse
Snillrik SnowFlowTwo
door MattiasKallio
3
Downloads
6
Likes
0
Makes
It's an old fpv-drone parts thingie for ice and maybe water.
Print two mounts for the bottles, one of them mirrored.
Figure out how differntial thrust and mixes work in BF or iNav. You can do it without an FC too, but with FC it works a lot better and is easier to control.
This is a good link
[https://github.com/betaflight/betaflight/blob/master/docs/Mixer.md](https://github.com/betaflight/betaflight/blob/master/docs/Mixer.md)
But the basic idea is to select "custom" and then set motor one and two like this in iNav and it's something very similar in BF (ok, looked it up, it exactly the same).
mmix 0 1.000 0.000 0.000 -1.000
mmix 1 1.000 0.000 0.000 1.000
Update: I made a new holder for the bottles, it's just bit thicker.
Print two mounts for the bottles, one of them mirrored.
Figure out how differntial thrust and mixes work in BF or iNav. You can do it without an FC too, but with FC it works a lot better and is easier to control.
This is a good link
[https://github.com/betaflight/betaflight/blob/master/docs/Mixer.md](https://github.com/betaflight/betaflight/blob/master/docs/Mixer.md)
But the basic idea is to select "custom" and then set motor one and two like this in iNav and it's something very similar in BF (ok, looked it up, it exactly the same).
mmix 0 1.000 0.000 0.000 -1.000
mmix 1 1.000 0.000 0.000 1.000
Update: I made a new holder for the bottles, it's just bit thicker.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
