Thingiverse
Snorkelclip Simple
door d1rk058
7
Downloads
2
Likes
0
Makes
Simpel clip to connect a snorkel to your mask strap.
Works by threading zip-ties through the holes and around your snorkel. Inside curvature is for a 25mm diameter snorkel (Aqualung in my case), but most sizes will fit. Zip-tie holes are 8 x 1.5mm. Clip inside width and length are 4x30mm.
Be sure to print it laying on its side (see picture); this gives the highest strength for the 'hook' part
Works by threading zip-ties through the holes and around your snorkel. Inside curvature is for a 25mm diameter snorkel (Aqualung in my case), but most sizes will fit. Zip-tie holes are 8 x 1.5mm. Clip inside width and length are 4x30mm.
Be sure to print it laying on its side (see picture); this gives the highest strength for the 'hook' part
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
