Snow King pot / lamp

I took the solidified remix and cut off some of the shoulders etc.

I then also made a hole for a plant pot or light source. There's a hole for drainage or maybe a power cable. The side it's intended to sit on is "serrated" so it can dry underneath if necessary. It can also just about balance on the side it prints on too, depending on your infill etc. The pot hole is 100mm wide and 70mm deep I think. Check before printing, thats from memory.

You can just fit it in the ender 3 print bed. My bed has 10mm reduced due to the duct. It printed pretty stable for me at 2 walls, 0.6mm nozzle, petg, lightning infill, .3mm layer hgiht.