Thingiverse
Snow Lantern
von jvalta
5
Downloads
3
Likes
0
Makes
This is a decorative snow lantern I modeled and printed out of white PLA, use a battery powered candle with this.
The model is a 0.8 mm hollow shell with a 1mm thick base, I used the Fuzzy Skin-option with 0.1 mm of jittering in cura to make the outer surface appear a little more "organic", and to better hide the layer lines.
On some lower layers there is a tiny gap between the outer and inner walls so I used 50% infill with 0.8 mm walls, top and bottom were at 1.2 mm.
Printing time with my Kingroon KP3S was 6 hours 37 minutes with 60 mm/s speeds.
The model is a 0.8 mm hollow shell with a 1mm thick base, I used the Fuzzy Skin-option with 0.1 mm of jittering in cura to make the outer surface appear a little more "organic", and to better hide the layer lines.
On some lower layers there is a tiny gap between the outer and inner walls so I used 50% infill with 0.8 mm walls, top and bottom were at 1.2 mm.
Printing time with my Kingroon KP3S was 6 hours 37 minutes with 60 mm/s speeds.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!