Thingiverse
Snowball Maker 2.0
3
Downloads
1
Likes
0
Makes
Print more than one scoop and Pins.
Flat sides face the build plate
INSTRUCTIONS:
/i\ REMOVE ALL SUPPORTS /i\
align scoops so that the two semi-spheres line up,
insert axel into the hole on side of the handle,
lightly tap pins into both sides of the axle, if they don't fit properly use glue, you want it to be snug though.
Flat sides face the build plate
INSTRUCTIONS:
/i\ REMOVE ALL SUPPORTS /i\
align scoops so that the two semi-spheres line up,
insert axel into the hole on side of the handle,
lightly tap pins into both sides of the axle, if they don't fit properly use glue, you want it to be snug though.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
