Snowball Maker

!!! UPDATE V3

The snowball clips sold are very large and require both hands to operate, which greatly reduces the efficiency: clamp the snow with both hands, release the clip, and hold the snowball with your hands, slowly, too slowly.

Use this, insert your thumb into the round hole, clamp the small ball between your index and middle fingers, grab a handful of snow, and a snowball will be formed. Press it with the other hand to make it stronger, and then you can throw it out (pay attention to safety and do not throw it out) Throw the clip out too)

One-piece molding, one model is printed directly. After printing, it can be used together. 0.4mm is reserved for the hinge axis. Under normal printing conditions, the two halves will open and close smoothly.

It looks a little small for adults, and the maximum opening angle is about 35 degrees. For hand-made models, it is recommended to adjust the model proportions​. It is 100% usable, but it needs to be refilled several times when