Slicer Discord
Snowball Mini Trebuchet  – 3D-printbaar model van MakerWorld MakerWorld
Outdoor Toys

Snowball Mini Trebuchet

8 Downloads
12 Likes
0 Makes
Model downloaden
This is a fun snowball launcher for snowball fights that will bring victory to you! ⭐ How to Use the Mini Trebuchet (Full Instructions)This mini trebuchet is designed to launch small snowballs, foam balls, cotton balls, marshmallows, or other soft, lightweight projectiles. It is easy to operate and safe when used properly. Follow the steps below for the best performance.πŸ“Œ 1. Set Up the TrebuchetPlace the trebuchet on a flat, hard surface like a table, floor, or driveway.Make sure the front (long arm side) is pointing toward your target.Keep the area clear in front of the trebuchet for at least 10–20 feet.πŸ“¦ 2. Add CounterweightYour trebuchet throws farther if the counterweight is heavier.Open the counterweight box (if yours is hollow).Add coins, bolts, washers, sand, or tiny rocks.Close it and make sure the weight is secure and will not spill out.Do not overfill; if the trebuchet flips forward when you fire, reduce weight.🎯 3. Load the ProjectileLift the long arm until the counterwei
Categorie
Outdoor Toys
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
uitgebreide nabewerking
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 2/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Schuren, Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord β˜• Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie