Snowboard/Ski Holder

This print-in-place holder is designed for the 2024 Toyota Tacoma rail system but may fit other trucks. It features a movable joint that slides in and out for easy storage and includes a latch cut-out with optional 5x3mm magnet holes for a secure fit. Specifically meant for smaller truck beds where boards won't fit straight, this design allows you to set a snug angle using the rail system. It has been field-tested all season with a single board and remains stable without sliding or flipping, though crossing the slots can provide even better balance. These were printed in PETG & PLA using an extra draft profile with manual supports enabled for the arm and latch. I don't doubt other filaments and settings will make it stronger that's just what I had on hand and it's been holding up just fine sooooo… Protect ya boards