Thingiverse
Snowboard Vise
door 4numen
129
Downloads
108
Likes
1
Makes
This is a 3d printable Snowboard Vise.
Store prices were ridiculous so I have designed my own.
Vise is very simple to enable fast printing & low resolution.
You will need:
-large printbed 20x25 cm (200x195 mm version now added)
-threaded bolt 10mm
-screw 17mm (optional, works without it, but once PLA thread wears out you can insert the screw-> see picture)
Ball & plate are optional, I've added them to reduce damage to the table.
I have additionally added a very thin layer of silicone at top (to improve snowboard hold) and at bottom (touching table) so less tension is needed.
Happy waxing & sharpening of the board!!!
Store prices were ridiculous so I have designed my own.
Vise is very simple to enable fast printing & low resolution.
You will need:
-large printbed 20x25 cm (200x195 mm version now added)
-threaded bolt 10mm
-screw 17mm (optional, works without it, but once PLA thread wears out you can insert the screw-> see picture)
Ball & plate are optional, I've added them to reduce damage to the table.
I have additionally added a very thin layer of silicone at top (to improve snowboard hold) and at bottom (touching table) so less tension is needed.
Happy waxing & sharpening of the board!!!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
