Snowman & Ultiman maker

Now we have some snow in The Netherlands, it's time to create some snowman's.
First I went for the minimal design, but that needed a little improvement, so here is v02.
I printed this version w/o support, within 4.5 hours per piece (including 4 pins in total).
Just glue those pins in the closed hole. The open hole is there for letting the snow pushed out. (That was a first mistake in v01.)

Then I was thinking about more interesting designs and added a UBot mold too.
Just put it down on the flat side and don't forget to print & glue those 4 pins.

Have fun creating some snowman's ;)