Thingiverse
Snowman Ornament
von Xelarim
3
Downloads
2
Likes
0
Makes
A unique snowman ornament. If I where to print this again I would try printing it upside-down, the supports in the center can be a pain to remove.
I would recommend simulating various support methods to limit them around the detailed snowflake on the back
I would recommend simulating various support methods to limit them around the detailed snowflake on the back
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
