Slicer Discord
Snowplough – 3D-printbaar model van Thingiverse Thingiverse

Snowplough

door IronMink
13 Downloads
36 Likes
1 Makes
Model downloaden
Here are files for a Southern Railway Snowplough. The files are drawn full size so shall need scaling to suit your model.

This weird looking beastie is a double ended snowplough, two of which were built by the Southern Railway in 1929, numbered S1 and S2. The winter of 1928/29 was particularly severe being the 5th coldest of the 20th century in the UK.

The design is double ended so could be propelled in either direction as a plough. It was normally stored with both headstocks raised (using the beam on the top), and then one headstock lowered into the body to become a plough.

Following the terrible winter of 1946/47 where the lowest temperature of -21Celsius was recorded in Kent, and the severe cold snap in February 1948 which mainly affected the South East with snow drifts and temperatures down to -18C, two more were ordered. These were built by British Railways as S3 and S4

The only difference between the SR and BR versions as far as I can see is the position of the build
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
zeer grote print
Eendelig Mogelijk schalen/splitsen nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 3/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Min. bedgrootte
300 mm (Zeer groot)
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

4 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie