SnubSquare Puzzle

The puzzle consists of 6 puzzle pieces and a slider box.

There are 2 solutions. The puzzle pieces are used on both sides.


3D Printing Tips
The size of the sliding top is crucial. If it's too narrow, the bumps on the top won't snap into place. If it's too wide, the top can usually still be inserted, but it becomes difficult to open.
If the lid is slightly too large, you can start by sanding down the bumps slightly. If the top doesn't fit, it is advisable to adjust its dimensions in the slicer and reprint it. Recommended adjustments are only small increments ranging between approximately 0.2mm and 0.3mm in width (only in width).

Here is a short video explaining this
https://www.youtube.com/watch?v=vve-SCg9ln8&t=2s


I printed the puzzle with the following settings:

Material: PLA
Resolution: 0.2mm
Infill: 20%
no supports
no raft, no brim



Further information about the SnubSquare Polyforms
The SnubSquare grid consists of squares and equilateral triangles, with a ratio of squares t