Thingiverse
SnusMaster
by uvens
27
Downloads
30
Likes
1
Makes
2020-05-21
A comment from https://www.thingiverse.com/Goofster who made this is to scale down all parts to 80% to get the correct size.
2018-12-13
Made a stronger model of the outer shell. Noticed that if using old PLA it could break so I made a stronger model called snusmaster_v2.stl
A charger that can be used for snuff tobacco. Apply a slice of snuff straight from the dose to the mouth without smearing your fingers.
Note: Tobacco can be dangerous to your health!
Can be printed in PLA in one piece. Infill 100%, resolution 0.23, 3 shell to make it sealed. Spent very little support. Lowered the print speed a little. You can tap a little on the inner bottom to loosen the inner part. Maybe ABS is best but trickier to print.
A comment from https://www.thingiverse.com/Goofster who made this is to scale down all parts to 80% to get the correct size.
2018-12-13
Made a stronger model of the outer shell. Noticed that if using old PLA it could break so I made a stronger model called snusmaster_v2.stl
A charger that can be used for snuff tobacco. Apply a slice of snuff straight from the dose to the mouth without smearing your fingers.
Note: Tobacco can be dangerous to your health!
Can be printed in PLA in one piece. Infill 100%, resolution 0.23, 3 shell to make it sealed. Spent very little support. Lowered the print speed a little. You can tap a little on the inner bottom to loosen the inner part. Maybe ABS is best but trickier to print.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
