Thingiverse
SO-239 Breakout box
by Re111111
1
Downloads
3
Likes
0
Makes
this is a SO-239 breakout box that has a semi circular mount to connect to a ~1.25" tube (mine is connected to my vertical)
Uses two zip ties to secure
use a panel mount SO-239, solder your wires to the back of the mount and feed through the hole. I used silicone to seal the exit hole, the threaded section and around the connector itself.
exit hole is big enough for 2 14AWG THHN wires, i didnt try #12
If using outside use an appropriate filament, I used PETG
It should load in the proper printing orientation, only supports needed might be the zip tie channels
Uses two zip ties to secure
use a panel mount SO-239, solder your wires to the back of the mount and feed through the hole. I used silicone to seal the exit hole, the threaded section and around the connector itself.
exit hole is big enough for 2 14AWG THHN wires, i didnt try #12
If using outside use an appropriate filament, I used PETG
It should load in the proper printing orientation, only supports needed might be the zip tie channels
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
