Slicer Discord
3DSEARCH / Electronics / SO-239 cap
SO-239 cap – 3D printable model from Thingiverse Thingiverse
SO-239 cap – Bild 1 SO-239 cap – Bild 2
Electronics

SO-239 cap

by NitzscheModellbau · Electronics
92 Downloads
42 Likes
0 Makes
Go to Model
If the thread comes out a little bit to tight you can warm up the cap with a heat gun and screw it back and forth a few times then it will work nice.
Category
Electronics
Source
Thingiverse
Published
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Antenna mount cap (SO-239)
Antenna mount cap (SO-239)
by NitzscheModellbau
↓ 32 ♥ 17
UHF PL-259 Connector Caps Cover Ham CB Radio
UHF PL-259 Connector Caps Cover Ham CB Radio
by 3D_Druck_Rafael
↓ 251 ♥ 50
Presidnet Randy III, holder for the antenna cap chain
Presidnet Randy III, holder for the antenna cap chain
by mason_swiss
↓ 1 ♥ 1
HAM radio CB antenna mast end cap for 25 mm and 30 mm tube
HAM radio CB antenna mast end cap for 25 mm and 30 mm tube
by hsc2k
↓ 10 ♥ 7
CB Antenna cap
CB Antenna cap
by Ender
↓ 4 ♥ 2
Breedlove Quick Release Mount Cap
Breedlove Quick Release Mount Cap
by wadealex
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
· Impressum · Privacy
DE EN FR ES IT NL

Add to Collection