Soap-bottle Counter Drain

EDIT: 3-12-2018 I've added a full sized version because i just realized i can save a file after resizing in cura. This new version requires less support because I've changed it's orientation. For the actual size read the paragraph just below this one but switch the Y and Z parameters in your head.

My mom made a passing comment about getting water on her counter when she went to use the soap bottles, so this soap bottle drain came to mind. I designed it to be used with two 7cm wide circular shaped bottles with personally desired dimensions of 150mm X, 91.5mm Y, 33.2mm Z.

IF YOU DO NOT DOWNLOAD THE "LESS SUPPORT" VERSION you will have to resize it, as it loads into the slicer 750% smaller than my mentioned dimensions.

I've made hollows on the bottom four corners where you can glue in some rubber/silicone feet depending on the type of filament you decide to use.

I'd suggest you coat the entire thing in some kind of hydrophobic layer.

You could also add silicone/rubber/high