Soap Dish

This is the soap dish design that came into my mind every time I encountered a bar of soap dissolving into the pool of water that it was sitting in.

Rather than attempting to print the thing in one piece (which would require a lot of support and so cleanup) I have printed the ones I have made in two halves (upper and lower) , which then don't need any support, in ABS, and stuck the two halves together with acetone and then vapour-smoothed that construct to give a more easily washable smooth surface.

Given that the outer surface is intended to be smooth printing with a small layer height is appropriate (~ 0.1mm), along with a reasonably high infill percentage (30-50%).