Soap Dish with drainage (Large)

A soap dish with a drainage hole to drain into an adjacent sink. I used it to deal with dripped water by a liquid soap dispenser but you could also hold a solid soap bar in it.This later model has broader, gentler slopes than the Small variant, as well as a standoff base intended to reduce slippage on wet surfaces and aid drying underneath. Of course you can scale one model up in size or the other down if you wish. 0.08mm Layer Height print profile (Recommended):Cleaner finish and much better underside surface quality, as well as easier-to-remove support job.Updated 19/01/2025: Spout side UP to maintain best surface quality on presentation face Notes:-SuperTack plate-Classic wall generator (Arachne produces a weird spot near the front of the dish)-0.4mm nozzle-Supports ON (pre-supported)Ironing not necessary. 0.20mm Layer Height print profile:Comes with variable height layers for a good balance between a smooth drainage channel and printing speed. Notes:-0.4mm nozzle-Ironing ON-Support