Thingiverse
Soap Holder for Rings
by Worti2
3
Downloads
1
Likes
0
Makes
We had two glass soap dishes until someone took the soap, the glass stuck to the soap, and then the glass didn't stick to the soap.
So I designed a new soap dish. I felt that two separate pieces were better. The first one to put the soap on and the second one to catch the mixture of water and soap.
Unlike usual, I took CorelDraw2019 to help and designed a half cross section. Then in Blender I used the spiral modifier. Now some honeycombs as holes and ready.
No, not quite finished yet. I printed with PETG and sprayed the print with transparent plastic primer. So the print can be cleaned relatively easy.
Diameter of the ring is 59 - 60 mm. The foot I have created is having a diameter of 58 mm.
Have fun with it.
So I designed a new soap dish. I felt that two separate pieces were better. The first one to put the soap on and the second one to catch the mixture of water and soap.
Unlike usual, I took CorelDraw2019 to help and designed a half cross section. Then in Blender I used the spiral modifier. Now some honeycombs as holes and ready.
No, not quite finished yet. I printed with PETG and sprayed the print with transparent plastic primer. So the print can be cleaned relatively easy.
Diameter of the ring is 59 - 60 mm. The foot I have created is having a diameter of 58 mm.
Have fun with it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!