Thingiverse
Soap Holder with drain
por BigRed3234
4
Descargas
4
Likes
0
Makes
Available for dual extrusion as well as single extrusion. Dual extrusion is broken up into a bottom and top half. To make your life a bit easier, raise the top section by 5mm to have it fit perfectly on top of the bottom (just make sure that the drain slots line up, you may have to rotate 180 to have the drain slots line up correctly).
As always, I would love to see any makes or remixes from this design! Enjoy!
As always, I would love to see any makes or remixes from this design! Enjoy!
BigRed3234 también publica en
2 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
