Thingiverse
Soap holder with or without drain
di MechDonald
1
Download
2
Likes
0
Makes
A simple holder for a soap. To make it easy to clean, it is split up in two parts.
The bottom part is available in two versions:
- with drain for excess water
- without drian for excess water
You might want to use a small layer hight or adaptive layer when printin the lid. This way the stairs in the lid will be less noticable, as the top of the lid has a slight concave form.
The bottom part with a drain has a slightly tilted ground inside to let the water flow out.
The outer diameter of the bottom part is around 120 mm, but you can scale it together with the lid in your slicer settings to fit your needs.
The bottom part is available in two versions:
- with drain for excess water
- without drian for excess water
You might want to use a small layer hight or adaptive layer when printin the lid. This way the stairs in the lid will be less noticable, as the top of the lid has a slight concave form.
The bottom part with a drain has a slightly tilted ground inside to let the water flow out.
The outer diameter of the bottom part is around 120 mm, but you can scale it together with the lid in your slicer settings to fit your needs.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
