Thingiverse
Soap mold Spiderman
von Ashak1el
4
Downloads
10
Likes
0
Makes
1) The mold consists of 4 parts and is assembled using 4 bolts and nuts M6. You can use printed ones, strong tightening is not necessary.
2) Before pouring melted soap, grease all parts of the mold well with Vaseline or another release agent.
3) When you assemble the mold, seal it with tape around the perimeter on all sides except the top part with the hole.
4) If the soap shrinks after hardening and a recess forms at the pouring point, simply add more melted soap into it.
2) Before pouring melted soap, grease all parts of the mold well with Vaseline or another release agent.
3) When you assemble the mold, seal it with tape around the perimeter on all sides except the top part with the hole.
4) If the soap shrinks after hardening and a recess forms at the pouring point, simply add more melted soap into it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
