Soccer Cone Grabber

Created this using the mechanism from FrostFPV, redesigned to fit a variety of "poles" including an extendable magnet grabber or similar that can be glued or screwed into place and includes a third wing fit to larger holes without falling off as easily.

Fits cones with a minimum 45mm hole, up to about 55mm (the sizes of my cones varied by manufacturer, this one fit with all of them).

The recessed hole in the top is 12mm wide by 10mm deep; fit my needs. STEP file is attached to edit as required.

Needs:
- Cone_Grabber_Mount (print x1)
- Cone_Grabber_Wing (print x3)
- M3x25mm screws (x3)
- Screw or glue for attaching stick.

For the M3 screws, a bit longer is fine, shorter won't really work. Larger screws need to be drilled out; too large will cut through the edge. With my printer settings the M3 is able to self-tap into the plastic (3.15mm hole in the model), your results may vary.