Thingiverse
Soccer Goal Corner Joint
by Gargoles
1
Downloads
5
Likes
0
Makes
Replacement Soccer Goal Joint for portable / collapsible soccer goals eg. Franklin Blackhawk.
Ideally for 8mm diameter polls but with tolerance, 11 mm diameter slots.
Small hole on the bottom is for rope up to 5mm diameter to pull corners together. It's placed to be as close to the ground as possible to lower chance it'll get in the way during game.
Curve/holes are to more evenly distribute stress.
Walls are 5mm thick for durability. Recommend printing with 100% inflill to make it closer in strength to original steel part.
Rounded edges for safety.
Avoid leaving in hot vehicles, especially if printing in PLA/PLA+; heat may warp or change dimensions of part.
Ideally for 8mm diameter polls but with tolerance, 11 mm diameter slots.
Small hole on the bottom is for rope up to 5mm diameter to pull corners together. It's placed to be as close to the ground as possible to lower chance it'll get in the way during game.
Curve/holes are to more evenly distribute stress.
Walls are 5mm thick for durability. Recommend printing with 100% inflill to make it closer in strength to original steel part.
Rounded edges for safety.
Avoid leaving in hot vehicles, especially if printing in PLA/PLA+; heat may warp or change dimensions of part.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!