Thingiverse

Soda Sprinkler - using Mentos

by dapoopta

19 Downloads

7 Likes

0 Makes

Fill tube with mentos, place a pin in the little hole to hold them in.. screw on to a bottle (2L most likely preferred for maximum spray). Then watch the soda spray!

I barbed the end of the tubes to allow hoses to be attached. The outer diameter of the barb is tapered from 0.40" to 0.50". This should allow for a 1/2" tube to be put on the end. Might not be needed, but could add a little fun to this thing.

Enjoy!

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format