Thingiverse
Soda Stream Bubly Drops Holder
von anthonyh24
0
Downloads
4
Likes
0
Makes
# Hold your bubly drops six at a time!
Didn't see a design a liked so I drew this one up from scratch real quick and after a test print, it fits perfect! Should fit on almost any print bed, doesn't take up a lot of room and is pretty quick to print.
I used the default Cura settings for medium PLA and it worked well.
### Fitment Issues
Bottles fit snug into the holes but not too tight. If it is too tight/loose, consider increasing/decreasing the scale by a very small percent and it should still work as intended.
Didn't see a design a liked so I drew this one up from scratch real quick and after a test print, it fits perfect! Should fit on almost any print bed, doesn't take up a lot of room and is pretty quick to print.
I used the default Cura settings for medium PLA and it worked well.
### Fitment Issues
Bottles fit snug into the holes but not too tight. If it is too tight/loose, consider increasing/decreasing the scale by a very small percent and it should still work as intended.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
