Thingiverse
Sodastream Bottle Wall Mount
von robertskogvold
23
Downloads
11
Likes
0
Makes
I made these models so that I could attach the Sodastream bottle to the wall.
There is four models:
- Bottom: Sodastream_Holder_1
- Top single version: Sodastream_Holder_3
- Top Hinge version: Sodastream_Holder_2_Part_1 and Sodastream_Holder_2_Part_2
The hinge version needs the following:
- 1 pcs 6 mm partially threaded bolt (at least 34 mm without threads) as a pin for the hing. Cut it at 34 mm from the head.
I used the lathe to make the head round, but that is not necessary.
- 1 pcs 16 mm partially threaded bolt (at least 34 mm without threads) for the lock mechanism. Cut out a 34 mm piece of the non threaded part. Drill a hole in the center with 6 mm threads.
- 1 pcs 6 mm threaded bolt as locking bolt
- 4 pcs Screws to attach the mounts to the wall. I used 3 mm screws.
Have a look at the pictures to see how I did this.
There is four models:
- Bottom: Sodastream_Holder_1
- Top single version: Sodastream_Holder_3
- Top Hinge version: Sodastream_Holder_2_Part_1 and Sodastream_Holder_2_Part_2
The hinge version needs the following:
- 1 pcs 6 mm partially threaded bolt (at least 34 mm without threads) as a pin for the hing. Cut it at 34 mm from the head.
I used the lathe to make the head round, but that is not necessary.
- 1 pcs 16 mm partially threaded bolt (at least 34 mm without threads) for the lock mechanism. Cut out a 34 mm piece of the non threaded part. Drill a hole in the center with 6 mm threads.
- 1 pcs 6 mm threaded bolt as locking bolt
- 4 pcs Screws to attach the mounts to the wall. I used 3 mm screws.
Have a look at the pictures to see how I did this.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
