Softube console 1 stand MKII (A1 MINI+)

I really needed A stand to hold both of the softube console 1 and fader mkII units with good cable clearance and low material cost.for stability I chose to use three lenghts of 50cm of 6mm threaded rod to connect the two sides but if you have a better idea feel free to modify the file however you please. the wishbone diagonals are very much needed to stop the tops splaying out the middle rod is optional but it does provide a ton of stability where the centre may flex over time. both of the hardware units are around 41.5cm wide I would sandwich the sides between bolts and washers on either end instead of threading the PLA like I did as its hard to thread it through both at once and correct maintain distance. Also my preset includes top surface ironing which does add alot of time to the print but It is more than worth the result in my opinion. If you have a textured print plate you could disable the ironing and just flip the sides so the texture shows instead on the exterior.