Thingiverse
Solar stirling engine stand
por Fisherman14
203
Descargas
178
Likes
0
Makes
I built this printed solar stirling engine from a construction manual from www.reprap-windturbine.com
The engine works really nice, only the stand is very weak. When I run the engine outside in the garden and there is wind it shakes and sometimes it tilts with the original stand.
The pictures show the old stand (black) and my new design (blue). The new one is much more stable in the wind, especially when the big solar reflectors are built on.
You need the following printed parts:
2 x Stand
1 x Upper tube
2 x Lower tube (Cut 4 x M4 threads. See picture!)
2 x Extention
Other parts:
4 x Screw M4x40mm
6 x Washer M
1 x Screw M4x60mm
The engine works really nice, only the stand is very weak. When I run the engine outside in the garden and there is wind it shakes and sometimes it tilts with the original stand.
The pictures show the old stand (black) and my new design (blue). The new one is much more stable in the wind, especially when the big solar reflectors are built on.
You need the following printed parts:
2 x Stand
1 x Upper tube
2 x Lower tube (Cut 4 x M4 threads. See picture!)
2 x Extention
Other parts:
4 x Screw M4x40mm
6 x Washer M
1 x Screw M4x60mm
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
