Solder Roll Stand

This is the right most stand on the picture.

It fits rolls with following dimensions:
Outer Diameter: 55mm
Inner Diameter: 19mm
Width: 30mm

Print the base at 30mm/sec, >50% infill (depending on how many solid layers/perimeter walls you choose) and hope that your retraction settings are dialed in.

The roller is printed with 5% infill up to 35.50 mm, from where you need at least 50% infill (for the smaller diameter end to build on). This can be achieved in Simplify3D with two processes.
Supports are also needed for the roller.