Solder Spool Holder with Guide - 2 Sizes

Simple print that holds solder spool(s). Designed so the center shaft snaps into place and does not fall out.It can still easily rotate and be removed to swap out spools.There are (2) included sizes:Small → Fits up to 30mm wide spool58 minute print timeLarge → Fits up to 60mm wide spool(s)1 hour 17 minute print timeThe center shaft has a diameter of 14mm.Large version requires some supports and a brim, but they are included in the print profile. Optional, but you can add small rubber feet to prevent it from sliding on your work surface.The bottom has (3) pre-defined locations to stick the rubber feet.https://amzn.to/4d9nz1M Try my Soldering Wire Holder:Soldering Fingers / Helping Hand / Wire Holder