Thingiverse
Solder spool stand
door vk5zbr
53
Downloads
30
Likes
0
Makes
Yes another Solder stand.
This is a stand for your beloved solder roll
I made this in PLA, have not tried ABS.
Cura 3.2.1 with Anycubic default setting imported from Cura 15 that came with the printer.
When slicing switch on supports and ironing for a better finish
I created the simple spool when I realised the other did not fit one of my solder real.
But if you like the spool with the ends make the two bit version. May need a little sanding to make it not such a tight fit.
Have fun
This is a stand for your beloved solder roll
I made this in PLA, have not tried ABS.
Cura 3.2.1 with Anycubic default setting imported from Cura 15 that came with the printer.
When slicing switch on supports and ironing for a better finish
I created the simple spool when I realised the other did not fit one of my solder real.
But if you like the spool with the ends make the two bit version. May need a little sanding to make it not such a tight fit.
Have fun
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!