Thingiverse
Soldering Iron Tip Case
por elceenor
9
Descargas
2
Likes
0
Makes
A case for up to 8 Hakko soldering iron tips.
To build this, you need:
2x 20x5x2mm magnets ([I used these ones](https://www.amazon.com/gp/product/B07KPX36YX/))
3x M3x8 bolts (M3x5 - M3x16 should work)
You need a M3 tap, for the M3 bolts. If requested, I can make a version that uses M3 nuts instead without any tapping necessary.
You also probably want a heat gun to mold the 3D printed hinge into form slightly.
Finally, I'd recommend placing the magnets into the slots *as it prints* - you can add them after, but then you'll need to glue them in.
To build this, you need:
2x 20x5x2mm magnets ([I used these ones](https://www.amazon.com/gp/product/B07KPX36YX/))
3x M3x8 bolts (M3x5 - M3x16 should work)
You need a M3 tap, for the M3 bolts. If requested, I can make a version that uses M3 nuts instead without any tapping necessary.
You also probably want a heat gun to mold the 3D printed hinge into form slightly.
Finally, I'd recommend placing the magnets into the slots *as it prints* - you can add them after, but then you'll need to glue them in.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
