Soldering Tools Holder

Stand designed to hold soldering tools. Incorporates the following slots:

X-Tronic 3020 solder spool (Slides into side of print)
Solder sucker (desoldering pump)
150mm ruler
X-Tronic 3020 tool
MG Flux Paste (Tube and Plunger)
Solder Wick
Micro-shears (2)
Small Bit+Driver box

Notes:
- My initial design's slots for the ruler and tool too small, so I manually widened the slots after printing. This is visible in the photos. I corrected this, and the current STL includes the corrective changes.
- The two small cuts in the rear of the print - on either side of the solder spool slot - are only there so the stand fits neatly onto my specific shelf, which has protruding tabs. These cutouts can be removed when remixing.