Soldering Wire Holder - spring clamp version

Following the popularity of my other soldering aid, I recognised that there was a need to develop a version that would be better suited to holding thinner gauge cable for soldering purposes. Therefore I developed this new design, incorporating integrated spring clamps to gently hold the cables in the required position. It's a one piece design - no supports are required.This design will work for cables up to around 2mm outside diameter. I highly recommend using PETG for this print - not only for its improved heat resistance, but also to improve the spring response of the clamps.I welcome all comments - this was test printed on a P1s, using the standard 0.2mm layer profile. It's a tool, so not necessary to use better quality settings unless appearance is important. Following a couple of comments regarding the strength of the clamps - this model is for small diameter cables only, up to approx 1mm diameter. For additional strength, consider increasing the number of walls and the in