Solenoid motor

This is a functional model of solenoid engine. I already made one and for now it is working fine. I am sharing my SolidWorks 2014 files so if you want you can adjust the model as you see fit.

The following hardware will be needed to assemble the motor:

6mm balls for the flywheel ( not necessary, motor should work without them )
Coil wire ( I used 1mm wire )
2x 8x40 metal rod
2x Rectifier diode
1x Capacitor 1000u/25V
2x Micro roller switch - you can find it on ebay :
10Pcs KW12-3 Micro Roller Lever Arm Normally Open Close Limit Switch


Assembly instructions :

1. Print all necessary parts.

2x Conecting_rod
2x Piston_onnecting_rod
2x Coil_holder1
2x Coil_holder2
1x Commutator
2x Piston_holder
1x Conecting_rod_top
2x Wall
1x Crankshaft
1x Ignition_wheel
1x Flywheel
( I suggest using 30% honeycomb infill , supports only if the are needed )

2. Glue together Coil holder1 and Coil holder2 parts with acetone. Then you will need to wound coils on them.