Solitaire FPV and Navigation Drone.

My attempt at a DIY drone. Thank you to KushalWagle for his lock nuts as I lost one. His design is non-commercial.
Use whatever stls you like to make your own drone.
This design is for 1045 props, 20A esc, 920kv motors, omnibus f4 v3 pro, a pdb, skyzone fpv, flysky 10 channel txrx, gps, mag and some leds I found.
The drone arm has air inlets to aid esc cooling. The base has air inlets to aid fpv tx cooling. The battery connector fits nice and tight in the top part.
M3 bolts and lock nuts used.
Printed in pla except legs, motor spacers, and tx, rx, fc, pdb holder and camera holder which where done in tpu. Do the legs at 100% on a raft. There are spacers that fit in the body to accommodate my 3300 lipo. Sponge washers used on fc.
Any question, I will try to answer.

Oh... and yes, it does fly.

Update. Sorry... Use Solitaire Drone(7) for arm. https://www.youtube.com/watch?v=TOQZHF-UXPA&t=246s