Sombra Cosplay Set

All the props required to cosplay as Sombra minus the clothing and gun. For all of these models an FDM printer using basic supports will work. Though you can use dissolvable supports, nothing requires it. Additionally, while FDM works for the lights, for best results we recommend that you print all of the lights on an SLA printer. Clearances are built in at 0.2mm but some pieces may require additional sanding to fit together.

For the EMP you will want to sew the backplate into your costume and then use 12mm diameter by 3mm thickness magnets to attach/detach it. Once printed it should be obvious where the magnets go. This is the same for the translocator pieces, except they use 6mm diameter by 3mm thickness magnets.

Epoxy should be good enough to attach most of the pieces to the coat/bodysuit. If the coat uses fabrics that epoxy doesn't adhere to, sew in small cotton patches and the epoxy will grab on to the patches.

For the silicone molds, you will want to hot glue them onto a