Thingiverse
Some basic accessories for the Zesty Kryo
von ZestyTech
10
Downloads
8
Likes
0
Makes
Changes:
1. Somebody remarked that the shrouds were difficult to print without support, so I added some internal structures and a sacrificial layer in the vent holes. I printed a shroud and it printed fine. Thanks, Zylantha!
Here are a few basic accessories for the Zesty Kryo.
There are two fan ducts and a Ber-air tube holder.
More will be added if requested.
The Kryo is a water-cooled heat sink for the E3D V6. It is a direct replacement of the aluminium heat sink and makes the whole hot end 13 mm shorter (more usable Z-height) and 25% lighter.
Combined with the Zesty Nimble it will make for a very light and effective print head.
The STL models are checked and optimised.
The Kryo and Nimble are available from [Zesty Technology.](https://zesty.tech)
1. Somebody remarked that the shrouds were difficult to print without support, so I added some internal structures and a sacrificial layer in the vent holes. I printed a shroud and it printed fine. Thanks, Zylantha!
Here are a few basic accessories for the Zesty Kryo.
There are two fan ducts and a Ber-air tube holder.
More will be added if requested.
The Kryo is a water-cooled heat sink for the E3D V6. It is a direct replacement of the aluminium heat sink and makes the whole hot end 13 mm shorter (more usable Z-height) and 25% lighter.
Combined with the Zesty Nimble it will make for a very light and effective print head.
The STL models are checked and optimised.
The Kryo and Nimble are available from [Zesty Technology.](https://zesty.tech)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!