Somfy remote shade controller V2

This is Version 2 of my project:
Somfy remote shade controller
https://www.thingiverse.com/thing:2469542


After 2 years of using the first version of this device. I found that I needed to modify it to make it more durable and reliable.

The remote control tray is now heavier. This was necessary because the working of the buttons caused stress on the sides of the tray and over time the sides cracked. Additionally I modified the power cord hole in the remote control tray to enable the power cord to be removed without having to un-soldering wires from the Adafruit Trinket.

Next, I fixed the servo clip. The old one was a little tight and warped when used.

Finally, I fixed the button pusher. The pusher sometimes didn't work because it got hung up on the case of the remote control. I re-aligned the pusher and beefed it up a bit.

When you install the pusher note that it only goes on one way for the best alignment.

November 2019
My Adafruit Hazzah board went bad when my 5V