Slicer Discord
Sonic Buggy (39mm Dual Engine) – 3D-Druckmodell von MakerWorld MakerWorld
RC

Sonic Buggy (39mm Dual Engine)

von pb · RC
4 Downloads
23 Likes
2 Makes
Zum Modell
Hey! Thank you for checking this out. I think this design could be improved upon a lot! This vehicle was meant to be a POC but then it worked pretty well!If you are looking to make your own vehicle design, or just for a single engine, head here. The single engines have full commercial rights on them! I would love if you remix the shit out of the buggy, just please don't commercialize this exact design. We can't have sonic buggy pod races if they are all the same.Sonic Buggy (39 mm Dual-Engine Setup)The Sonic Buggy merges two 39 mm sonic ramjet nozzles with a wheel‑bearing chassis to create a unique demonstration of acoustic propulsion. By resonating ~40 Hz waves inside precisely shaped nozzles, this buggy achieves measurable forward thrust—no mechanical propellers or fans required. While the instructions reference certain electronics, nearly any compatible amplifier, speaker, and battery can be adapted, so long as the original geometry is preserved. Experiment freely with volta
Kategorie
RC
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen