Thingiverse
Sonic Pad Screen Protector
von ffinybryn
4
Downloads
8
Likes
0
Makes
A "print-in-place" hinged screen protector for the Sonic Pad. Protecting it against dust and scratches.
The protective cover is printed in one piece, includes two hinges and "snaps" in place (or it can be held with screws).
The cover rests on the raised edges of the front and does not touch the screen.
Minimum bed dimensions: 200mm (X) x 156mm (Y)
The 3D model includes a 0.5mm raft for the required supports - I found this helps with bed adhesion of the supports.
I did not need the automatically generated supports within the logo that 3D Simplify generated - and these were removed at the slicing stage.
The cover clicks in place, but AT YOUR OWN RISK, you can remove the two M3x8mm hex machine screws and replace them with two M3x20mm machine screws.
The photos show the item printed in white for clarity, but I prefer the black.
Settings used:
PLA: Nozzle 230C Bed 60C
Support: 30%
Infill: 20%
Recommended speed:
The protective cover is printed in one piece, includes two hinges and "snaps" in place (or it can be held with screws).
The cover rests on the raised edges of the front and does not touch the screen.
Minimum bed dimensions: 200mm (X) x 156mm (Y)
The 3D model includes a 0.5mm raft for the required supports - I found this helps with bed adhesion of the supports.
I did not need the automatically generated supports within the logo that 3D Simplify generated - and these were removed at the slicing stage.
The cover clicks in place, but AT YOUR OWN RISK, you can remove the two M3x8mm hex machine screws and replace them with two M3x20mm machine screws.
The photos show the item printed in white for clarity, but I prefer the black.
Settings used:
PLA: Nozzle 230C Bed 60C
Support: 30%
Infill: 20%
Recommended speed:
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!