Thingiverse
Gadgets
Go to Model
Sony camera RX100 grip
157
Downloads
143
Likes
6
Makes
Grip for Sony Rx100 compact camera.
Glue to camera with 0.25 mm thick 3M VHB double sided tape F9473PC.
The model should be printed upright for best result.
The built-in support on the back is very easy to break off after printing.
It prints without further supports, if the layer heights are as described in printer settings.
If printed with larger layer height external support is needed.
It is recommended to print more than one model at a time to allow the plastic to cool down between layers.
Glue to camera with 0.25 mm thick 3M VHB double sided tape F9473PC.
The model should be printed upright for best result.
The built-in support on the back is very easy to break off after printing.
It prints without further supports, if the layer heights are as described in printer settings.
If printed with larger layer height external support is needed.
It is recommended to print more than one model at a time to allow the plastic to cool down between layers.
ABH10 also publishes on
2 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
