Thingiverse
SOTABeams Power Conditioner Case
por grajohnt
9
Descargas
2
Likes
0
Makes
A printable case for the [SOTABeams Power Conditioner Kit](https://www.sotabeams.co.uk/wsprlite-power-conditioner-kit/)
This kit converts 7-20 VDC into very clean 5.1 VDC (@200 mA) for use in powering USB radio devices like the WSPRLite.
Additionally required for assembly:
* 6x M2x4 screws
* 6x M2x12 standoffs
(An additional M2 standoff can make screwing in the standoffs a bit easier)
It should be possible to use M3 hardware instead, but driling out / tapping the screw cylinders would probably be necessary.
The back is ventilated to provide some airflow over the heatsink on the back of the circuit board.
When constructing the kit, the LED should be stood off the board as much as possible to line up with the hole in the case.
This kit converts 7-20 VDC into very clean 5.1 VDC (@200 mA) for use in powering USB radio devices like the WSPRLite.
Additionally required for assembly:
* 6x M2x4 screws
* 6x M2x12 standoffs
(An additional M2 standoff can make screwing in the standoffs a bit easier)
It should be possible to use M3 hardware instead, but driling out / tapping the screw cylinders would probably be necessary.
The back is ventilated to provide some airflow over the heatsink on the back of the circuit board.
When constructing the kit, the LED should be stood off the board as much as possible to line up with the hole in the case.
grajohnt también publica en
30 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
