Source One v4 HD DJI O3 Camera Mount

** EDIT 1/1/2023 - I no longer use the O3 on the SO v4, but I'll leave this up in hopes that it helps someone else. It was a lot of fun to design and test. :-)**

This is a camera mount for the DJI O3 Camera in a Source One v4 / HD. This mount has limited props in view and the standoffs are not in view.

New install method:

It requires 2x 10mm standoffs (bottom) and 2x 5mm standoffs (top), as well as 2x 36mm (longer or shorter, depending) M3 bolts. You will need one M3 nut at the end, on the underside of the quad.

The mount measures 15mm.

Please ensure the front standoffs are securing the frame, as they are now acting together as your front standoff. The side camera panels should be locked in place and the top/bottom frame panels should be parallel once secured, with 30mm between them.

The camera holder frame portions must be cut back to accommodate the mount, and it is highly recommended that these be used for frame stability.

I was very particular about jelly / vib