Thingiverse
Source One V6 Parts
door John35588
3
Downloads
5
Likes
0
Makes
A few parts I've designed for my Source One V6 build. I have not tested these parts on other versions of the Source One. All parts are designed to be printed without supports.
I'm open to additional requests and ideas, so feel free to reach out!
#####Camera Protectors:
Thin, lightweight bumpers for the carbon fiber on either side of the camera. I printed mine in PLA, since TPU would be too floppy.
I would recommend using feet as well, or the protectors may hit the ground while landing.
#####RX Antenna Mount:
Tested with the stock antennas of the HGLRC ELRS 2.4 RX-T.
Uses three 2.6mm wide zip ties to secure the antenna.
#####VTX Antenna Mount:
Tested with the MMCX version of the Xilo AXII (using the TBS Unify Pro32 HV VTX in this case).
Uses a small section of a 2.6mm wide zip tie to keep the antenna secured at a gentle angle. Cut off the narrower tab on the end of the zip tie, then slide it into the slot once the antenna is where you want it. Then cut the zip tie, leaving just en
I'm open to additional requests and ideas, so feel free to reach out!
#####Camera Protectors:
Thin, lightweight bumpers for the carbon fiber on either side of the camera. I printed mine in PLA, since TPU would be too floppy.
I would recommend using feet as well, or the protectors may hit the ground while landing.
#####RX Antenna Mount:
Tested with the stock antennas of the HGLRC ELRS 2.4 RX-T.
Uses three 2.6mm wide zip ties to secure the antenna.
#####VTX Antenna Mount:
Tested with the MMCX version of the Xilo AXII (using the TBS Unify Pro32 HV VTX in this case).
Uses a small section of a 2.6mm wide zip tie to keep the antenna secured at a gentle angle. Cut off the narrower tab on the end of the zip tie, then slide it into the slot once the antenna is where you want it. Then cut the zip tie, leaving just en
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
