Sovol / Comgrow Drybox PTFE Radius Guide

I recently printed a mount adapter to move my Comgrow dry box to the top of my A1 and the ptfe coming from the top of the box was getting tweaked to a sharp angle and was no longer able to feed the mount I had mounted to the wall. (it was previously on the shelf in the top of this closet in my office thats been turned into a workbench and fed straight down into the wall mount.). I made a quick and dirty model that slides over a PC4-M10 connector and adapts down to fit a 4mm O.D. ptfe tube and hold it at a good angle to feed into the existing wall mount.I printed it in 2 pieces and used some CA glue to fix the tube adapter to the sleeve - I tried printing it in one piece and the prints kept coming out bad due to the need for supports so I split them. Since adding this the filament feeds from the drybox just fine… it may have been easier to replace the wall mounts but hey there were already 6 holes in the wall so here we are lol