Sovol SV01 BLTouch Holder

Although the original holder worked well, I found it to be a bit flexible, especially when it got warm. I added two gussets as well as a thicker fillet at the bend.
Originally i printed it in PLA but went to PETG after it sagged on me, (I had purchased some clearance PLA that was extremely brittle and the only way I could use it was to have a blow dryer heating the filament near the head. The extra heat softened the mount which through off my Z offset).

Print Parameters:
Material: PETG
NozzleTemp:240 first layer, 245 rest
BedTemp:70 first layer, 65 rest
Infill: 20%
Layer Height: .2
First Layer: .25
Horizontal shells: 3
Vertical Shells:4