Sovol Zero - Removeable 270 degree door hinges

SOVOL ZERO MOD270° Hinge, easily removeable, no additional screws or supports required. Feedback would be appreciated. WHAT IS IT?I think ALL printers should have 270 degree hinges. Especially those with glass doors. If it isn't against a wall, you should be able to get it out of the way. And if you are printing with the door open and the top off, why not just remove it? You can use all the existing screws to assemble these hinges. Version 1 was my initial creation. Looks intersting and works, but looked a little odd with 3 screws exposed. So I made version 2. PROTIP: The existing hinge screw is 30mm. If you have a 25mm sockethead screw, I would use that on the bottom hinge, so you can seat the top first, then the bottom.HOW TO PRINTLike Burger King, "have it your way!" I have printed tests on the flat side and standing up with no failures. Both with and without supports. So, it just comes down to what surface appearance you want. I used version 1 with 2 walls and version 2